AirSep VisionAire 5 Gebrauchsanweisung Für Patienten Seite 71

VisionAire™
Important Safety Rules
Carefully review and familiarize yourself with the following important safety
information about the VisionAire™ Oxygen Concentrator.
This device supplies high-concentration oxygen that promotes
rapid burning. Do not allow smoking or open flames within the
same room of (1) this device, or (2) any oxygen-carrying
accessory. Failure to observe this warning can result in severe
fire, property damage and / or cause physical injury or death.
This unit is not to be used for life-support. Geriatric, pediatric,
or any other patient unable to communicate discomfort while
using this oxygen concentrator may require additional
monitoring. Patients with hearing and/or sight impairments
may need assistance with monitoring the alarms.
If you feel discomfort or are experiencing a medical
emergency, seek medical assistance immediately.
Use no oil, grease, or petroleum-based or other flammable
products on or near nasal end of cannula or on the unit.
Oxygen accelerates the combustion of flammable substances.
Electrical shock hazard. Disconnect the power cord from the
electric outlet before you clean the unit to prevent accidental
electrical shock and burn hazard. Only your Equipment
Provider or a qualified service technician should remove the
covers or service the unit.
®
AirSep Corporation
MN137-1 rev. D
EN EN
EN-1 EN-2
Do not leave a nasal cannula under bed coverings or chair
cushions. If the unit is turned on but not in use, the oxygen will
make the material flammable. Set the I/0 power switch to the 0
(off) position when the VisionAire unit is not in use.
Do not use extension cords with this unit or connect too many
plugs into the same electrical outlet. This can result in an
overload to the electrical panel causing the breaker/fuse to
activate.
Use only voltage specified on back panel label.
Do not use your oxygen concentrator in the presence of
flammable gases. This can result in rapid burning causing
property damage, bodily injuries or death.
Care should be taken to prevent unit from getting wet or
allowing water to enter the unit. This can cause the unit to
malfunction or shut down, and cause an increased risk for
electrical shock or burns.
Disconnect the power cord from the electrical outlet before
you clean the unit to prevent accidental electrical shock
hazards. Only your Equipment Provider or a qualified
service technician should remove the covers or service
the unit.
Do not use liquid directly on the unit. A list of undesirable
chemical agents includes but is not limited to the following:
alcohol and alcohol-based products, concentrated chlorine-
based products (ethylene chloride), and oil-based products
(Pine-Sol®, Lestoil®). These are NOT to be used to clean the
plastic housing on the unit, as they can damage the unit's
plastic.
VisionAire™
®
AirSep Corporation
MN137-1 rev. D