Displayed Centrifugation Data After Switch-On; Set Temperature Unit; Centrifuge Address - Hettich ROTANTA 460 Robotic Bedienungsanleitung

25

Displayed centrifugation data after switch-on.

After switch-on the centrifugation data from program 1, or from the last program that was used, is displayed.
If the rotor is at standstill, this can be set as follows:
This setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Press the key as often as necessary until Start program = Last/First is displayed.
PROG

Use the adjusting knob
Last = the program used last, First = program 1.

Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.

Press the key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
26

Set temperature unit

The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F).
When the rotor is at standstill, the temperature unit must be set as follows:
This setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Press the key as often as necessary until Temp Unit = Celsius/Fahrenheit is displayed.
PROG

Use the adjusting knob

Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.

Press the key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
27

Centrifuge address

Ex works, the address is ] = 29. Address is set.
to set Last or First.
to set Celsius or Fahrenheit.
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
EN
71/155