Activating Or Deactivating The Cycle Counter; Activate Or Deactivate The Function, "Dual Time Mode - Hettich ROTANTA 460 Robotic Bedienungsanleitung

21.3

Activating or deactivating the cycle counter

The cycle counter can be activated/deactivated as follows when the rotor is at a standstill:
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Operating Time is displayed.
PROG

Press the key. The external operating hours are displayed, e.g. OP Time ext = 0h25m.
START

Press the key as often as necessary until (with the cycle counter activated) the rotor cycles are displayed,
PROG
e.g. Cycles = 5120 of 30000, and (with the cycle counter deactivated) until Cycles = disabled is displayed.

Deactivating the cycle counter:
 Press the key as often as is required until the maximum permitted number of rotor cycles is displayed
RCF
in parentheses  , e.g. Cycles = 5120 of 30000.
 Turn the knob to the left to reset the maximum permitted number of rotor cycles to "0".
 Press the key to save the setting.
START
In confirmation, Store cycles ... and Cycles = disabled is displayed briefly.

Activating the cycle counter:
 Press the key as often as is required until the maximum permitted number of rotor cycles is displayed
RCF
in parentheses  , e.g. Cycles = 0 of 0.
 Use the knob to set the maximum permitted number of rotor cycles specified on the hanger.
 Press the key to save the setting.
START
In confirmation, Store cycles ... is displayed briefly. Next the rotor cycles are displayed, e.g. Cycles = 0 of
30000.

Press the key twice to exit the "Operating Time" menu or press the
OPEN / STOP
exit the "Machine Menu".
22

Activate or deactivate the function, "Dual time mode"

The function "Dual time mode" can be activated or deactivated as follows when the rotor is at a standstill:
This setting can only be made via the operating unit (key position "0" or "LOCK 2"). The functions of the
various key positions are described in the "Key-operated switch" chapter.
You can scroll backwards through the menu by pressing the
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Settings is displayed.
PROG

Press the key. The SOUND / BELL = off/on is displayed.
START

Press the key as often as is required until Dual time mode enabled/disabled is displayed.
PROG

Use the knob to set enabled or disabled.
disabled = The function is deactivated,
enabled = The function is activated.

Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.

Press the key once to exit the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
OPEN / STOP
key.
T/°C
key. In this case, the settings are not
OPEN / STOP
key twice to exit the
OPEN / STOP
EN
key three times to
69/155