Entering Centrifugation Parameter; Programming; Programme Input/Alteration; Programme Recall - Hettich MIKRO 220 Bedienungsanleitung

EN
15

Entering centrifugation parameter

If no key is pressed for 8 seconds long after the selection or during the input of parameters, the previous
values will be shown in the display. The input of parameter then has to be executed again.
If no parameters can be entered, then the programs are write-protected. To cancel the write protection, see
the chapter on "Write protection for the programs").
•
Select the RPM or RCF display with the key
•
Select the desired parameters using the button
In order to set continuous operation, the parameters t/min and t/sec must be set to zero with the
Continual running is represented in the display by the following symbol, "".
•
After input of all parameters, press the key
position #. As confirmation,  ok  will be displayed for a short period.
The data on the programme position # will be overwritten with every input of parameters and pressing of the
key .
START / IMPULS
16

Programming

16.1

Programme input/alteration

If no key is pressed for 8 seconds long after the selection or during the input of parameters, the previous
values will be shown in the display. The input of parameter then has to be executed again.
If no parameters can be entered, then the programs are write-protected. To cancel the write protection, see
the chapter on "Write protection for the programs").
•
Select the RPM or RCF display with the key
•
Select the desired parameters using the button
In order to set continuous operation, the parameters t/min and t/sec must be set to zero with the
Continual running is represented in the display by the following symbol, "".
•
The parameter PROG STO can be selected using the button
the knob .
•
Press the button
START / IMPULS
displayed briefly as confirmation.
If the key
START / IMPULS
stored in the program place #.
The previous data in the program position is overwritten during saving.
16.2

Programme recall

•
Select the parameter PROG RCL using the button
.
•
Press the button
START / IMPULS
•
The parameters can be checked by pressing the button
To leave the parameter display press the button
46/107
. RCF values are displayed in > <.
RCF
SELECT
START / IMPULS
. RCF values are displayed in > <.
RCF
SELECT
in order to store the setting on the desired program position.  ok  is
is pressed without the parameter PROG STO being activated, the settings are always
SELECT
. The centrifugation data of the selected program position is displayed.
OPEN / STOP
Rev. 12 / 12.2022
and set using the knob .
in order to store the adjustments on the programme
and set using the knob .
and the desired program position set using
SELECT
and set the desired program position using the knob
.
SELECT
or press no button for a period of 8 seconds.
knob.
knob.
AB2200DEENFRIT