Optical Signal After Ending The Centrifugation Run - Hettich MIKRO 185 Bedienungsanleitung

• Press the button to save the setting.
START
PULSE

• Press the key once to exit the "
STOP
OPEN
Settings"
menu or press twice to exit the "
MACHINE MENU ".
20.3

Optical signal after ending the centrifugation run

The backlighting of the display flashes after the centrifugation run to visually signalize that the centrifugation run has
finished.
The optical signal can be switched on or off when the rotor is at a standstill:
The procedure can be aborted at any time by pressing the
• Press and hold the button for eight
SELECT
seconds.

• Press the key until the following is
SELECT
displayed.

• Press the key.
START
PULSE

• Press the key until one of the following is
SELECT
displayed:
End blinking : Backlighting of display
flashes after the centrifugation run.
off : Backlighting does not flash.
on : Backlighting flashes.

• With the keys, set off or on.
t

• Press the button to save the setting.
START
PULSE

• Press the key once to exit the "
STOP
OPEN
Settings"
menu or press twice to exit the "
MACHINE MENU ".
AB1203DEENFRIT
>RCF< RPM t/min:s
RPM
>RCF< t/min:s
STOP
OPEN
key.
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
RPM
>RCF< t/min:s
RPM
>RCF< t/min:s
>RCF< RPM t/min:s
RPM
>RCF< t/min:s
Rev. 08 / 12.2022
EN
>RCF< RPM t/min:s
Example:
RPM
>RCF< t/min:s
>RCF< RPM t/min:s
>RCF< RPM t/min:s
RPM
>RCF< t/min:s
Example:
RPM
>RCF< t/min:s
71/154