Returning Devices; Disposal - Hettich ROTANTA 460 Robotic Bedienungsanleitung

Message / fault
SENSOR-ERROR
SENSOR-ERROR 91 - 93
NO ROTOR OR
ROTORCODE
ERROR
N  ROTOR MAX
N > ROTOR MAX
in Prog : e.g. 3
Runtime 00:00
in Prog : e.g. 3
Empty Program
Ramp Unit Time in
Prog : e.g. 3
Acc time > Run time
FC INIT ERROR
FC VERSION ERROR
FATAL EEPROM 1 - 5
ERROR
WATCHDOG RESET
40

Returning Devices

Before returning the device, a transport securing device has to be installed.
If the device or its accessories are returned to Andreas Hettich GmbH & Co. KG, in order to provide protection for
people, the environment and materials, it has to be decontaminated and cleaned before being shipped.
We reserve the right to refuse contaminated devices or accessories.
Costs incurred for cleaning and disinfection are to be charged to the customer.
We ask for your understanding in this matter.
41

Disposal

Before disposal, the device must be decontaminated and cleaned to protect people, the environment and property.
When you are disposing of the device, the respective statutory rules must be observed.
Pursuant to guideline 2002/96/EC (WEEE), all devices supplied after August 13, 2005 may not be disposed as part of
domestic waste. The device belongs to group 8 (medical devices) and is categorized in the business-to-business
field.
The icon of the crossed-out trash can shows that the device may not be disposed as part of domestic
waste.
The waste disposal guidelines of the individual EC countries might vary. If necessary, contact your
supplier.
Cause
90 Error / defect electronics
Error / defect unbalance sensor
--- No rotor installed.
Faulty speedometer.
--- Speed in the selected program greater than
the maximum speed of the rotor.
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
--- There is a program in the displayed
program location whose speed is higher
than the maximum speed of the rotor.
The rotor has been changed. The
maximum speed of the installed rotor is
higher than that of the rotor that was
previously used and this has not yet been
detected by rotor recognition.
--- There is a continuous operation program in
the displayed program location.
--- There is no program linkage saved on the
displayed program location.
--- A program with start-up and/or run-down
time is located at the displayed program
place.
--- The set start-up time is longer than the run
time.
--- Error / defect electronics
--- Error / defect electronics
Error / defect electronics
Error / defect electronics
Remedy
 Perform a MAINS RESET.
 Open lid.
 Install rotor.
 Check the set speed.
Reduce the set speed
 Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
key to run rotor
START
recognition. See chapter, "Rotor
Recognition".
 Check the set speed.
Reduce the set speed
 Set a speed up to the maximum
speed of the rotor that was
previously used. Press the
key to run rotor
START
recognition. See chapter, "Rotor
Recognition".
 Replace the continuous operation
program in the program linkage
with a program with preset time.
 Call up a program linkage.
 Replace the program in the
program link with a program with
start-up and braking stage.
 Set a start-up time which is
shorter than the run time.
 Perform a MAINS RESET.
EN
81/155