Immediate Display Of The Centrifugation Data After Switching On; Key-Operated Switch; Program Linking (For Centrifuges With Program Linking Only); Linking Programs - Hettich ROTO SILENTA 630 RS Bedienungsanleitung

30

Immediate display of the centrifugation data after switching on

 Switch on the mains supply switch. Switch position .

Press any key apart from the
centrifugation data will be displayed immediately.
31

Key-operated switch.

The following program interlocks can be set by the key-operated switch:
Left key position: LOCK 1 will be displayed.
Programs can be called up but not changed.
Right key position: LOCK 2 will be displayed.
No programs can be called up or changed.
Middle key position: no status display.
No program interlock. Programs can be called up and changed.
32

Program linking (for centrifuges with program linking only).

Several centrifugation runs can be linked together with the help of the program linking function.
32.1

Linking programs

Program linking is only possible with programs in which run-up and braking steps have been set.
Before linking, the programs must be stored in the desired sequence either by entering the program or by
calling up the program (see Chapter "Programming").
The program locations must be consecutive (e.g. program locations 10+11+12).
1. Press the key in order to select the parameter PROG-Nr. The input field will be displayed inversely.
PROG
2. Set the program location for the first program (XX+) by means of the control knob
3. Press the key. The centrifugation data for the selected program location will be displayed.
RCL
4. Press the key twice in order to select the parameter PR-PART. The input field will be displayed inversely.
PROG
5. Press the key twice. The program will be linked and the program number for the next program location
STO
(+XX+) will be displayed.
6. Press the key twice. The centrifugation data for the selected program location will be displayed.
RCL
7. Press the key twice. The program will be linked and the program number for the next program location
STO
(+XX+) will be displayed.
8. Keep repeating steps 6 and 7 until all programs have been linked.
9. Press the key to exit. The program number for the last program (+XX) will be displayed.
PROG
32.2

Changing program links


Call up the desired program (see Chapter "Calling up programs"), change the desired parameters (see Chapter
"Entering centrifugation parameters"), and save the modified centrifugation data to the same program location
(see Chapter "Entering / modifying programs"). As a result of saving, the program linking will be removed.

Re-link the programs (see Chapter "Linking programs").
AB5005DEENFRIT
key when the first visual change appears in the display (inverse display). The
STOP
Rev.18 / 04.2023
EN
.
67/165