Adjusting The Waiting Period Of The Screensaver - G&D DP1.2-VisionXG-Fiber Installation Und Bedienung

Adjusting the waiting period of the screensaver

The screensaver turns off the display of the console after the user has been inactive
for a defined period of time.
NOTE: This setting does not affect the screensaver settings of the computer con-
nected to the computer module.
How to adjust the waiting period of the screensaver:
1. Press
Ctrl+Num
2. Select the row
saver of the remote console (at the
Select the row
screensaver of the local console (at the
3. Under
Screensaver (min)
screensaver.
Entering the value 0 disables the screensaver.
4. Press to save your settings.
F2
1. In the menu, click on
2. Click on the KVM extender you want to configure and then click
on Configuration
3. Click on the tab
4. Click on the tab
workstation (on the
Click on the tab
workstation (on the
5. In the Screensaver (minutes)
the screensaver.
Entering the value 0 disables the screensaver.
6. Click on Save
(default) to open the on-screen display.
Console setup and press
and press
Local console setup
enter a waiting period (1 to 999 minutes) for the
KVM extender .
.
General .
CPU if you want to configure the screensaver of the local
CPU module).
CON if you want to configure the screensaver of the remote
module).
CON
row, enter the waiting time (1 to 999 minutes) of
.
Enter if you want to adjust the screen-
module).
CON
if you want to adjust the
Enter
module).
CPU
G&D DP1.2-VisionXG-Fiber · 48
Configuration