Adjusting The Transparency Of The On-Screen Display - G&D DP1.2-VisionXG-Fiber Installation Und Bedienung

Adjusting the transparency of the on-screen display

In the default settings of the KVM switch, the on-screen display covers parts of the
screen content. However, the parts of the screen contents covered by the OSD are
still visible.
You can adjust the transparency level or turn the transparency off.
How to adjust the transparency of the on-screen display:
1. Press Ctrl+Num
2. Select the row
3. Select the row
4. Under
OSD transparency
 high transparency of the screen content
high
average  average transparency of the screen content (default)
low  low transparency of the screen content
 screen content is covered
off
5. Press to save your settings.
F2
1. In the menu, click on
2. Click on the user account you want to configure and then click
on Configuration
3. Click on the tab
4. In the OSD transparency
high  high transparency of the screen content
 average transparency of the screen content (default)
average
 low transparency of the screen content
low
off  screen content is covered
5. Click on Save
(default) to open the on-screen display.
Console setup and press
Personal Profile and press
press to select on of the following options:
F8
Users .
.
KVM extender systems
field, select between the following options:
.
Enter .
Enter .
.
G&D DP1.2-VisionXG-Fiber · 54
Configuration