Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Establishing a connection to the computer module
A
Transmission
IMPORTANT:
The device uses components with laser technology which comply
with laser class 1.
Never stare into the invisible laser beam when wearing optical instruments!
NOTE:
Remove the protection caps from the Transmission interface and the cable
plugs.
Transmission|Tx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Rx interface of the computer module.
Transmission|Rx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Tx interface of the computer module.
NOTE:
Connect at least one of the user module's Transmission sockets (two fibres)
to the computer module.
If the bandwidth of the cable connection(s) is insufficient for the transmission of the
signals, image errors occur. In this case, connect other transmission sockets to the
computer module.
Additional interfaces of expanded variants
DP Out
IMPORTANT:
The interfaces listed in this paragraph are only provided at certain
variants.
Line In:
Connect a microphone to this interface if desired.
Line Out: Connect the console speakers or another audio output device to this interface.
RS232: Connect the serial end device to this interface.
USB 2.0 Devices: Connect any USB device to these four interfaces.
13 · G&D DP1.2-VisionXG-Fiber
B
DP Out
Host
Link
USB 2.0 Devices
Host
Link
USB 2.0 Devices
Network B
Generic
Network A
Keyb./Mouse
PS/2
Network B
Generic
Network A
Keyb./Mouse
Line
In
Out
RS232
PS/2
Ready
Ident.
System
Fail
Werbung
Kapitel
Inhaltsverzeichnis
