G&D DP1.2-VisionXG-Fiber Installation Und Bedienung Seite 88

Installation
Connecting the computer's video output
A
Transmission
DP CPU: Use the DP-Cable-M/M-2 cable to connect the computer's video output to
this interface.
NOTE:
Each video channel of the MultiChannel variant is provided with one
interface. The numbers behind the interface names assign each interface to a given
channel.
Establishing a connection to the user module
NOTE: Each transmission line (data link via an LC duplex socket) is used dynami-
cally. The smaller the bandwidth required, the less transmission lines are required.
The higher the bandwidth, the more transmission lines are required.
The required bandwidth is mainly determined by the video signals to be transmitted.
The bandwidth is split between all available transmission lines. If an active link
fails, its bandwidth requirements are automatically divided between the remain-
ing line(s) if the remaining total bandwidth is sufficient.
A
Transmission
IMPORTANT: The device uses components with laser technology complying with
laser class 1.
Never stare into the invisible laser beam when wearing optical instruments!
NOTE: Remove the protection caps from the Transmission interface and the cable
plugs.
Transmission|Tx: Insert the LC plug of a fibre optic cable, which is available as acces-
sory. Connect the other end of the cable to the Transmission|Rx interface of the user
module.
9 · G&D DP1.2-VisionXG-Fiber
B
DP Out DP CPU
B
DP Out DP CPU
Network B
Host
Link
USB 2.0 CPU Network A
Network B
Host
Link
USB 2.0 CPU Network A
RS232
USB K/M PS/2
DP CPU
RS232
USB K/M PS/2