Starting And Exiting The Setup Menu; Basic Operation Of The Setup Menu; Setup Menu Functions; Showing Information About The Firmware - G&D Audio-Transceiver-Fiber Installationsanleitung

Configuration

Starting and exiting the setup menu

How to start the setup menu:
IMPORTANT: Before starting the setup menu make sure that the Service interface of
the signal extender is connected to the USB interface of the computer.
1. Start the terminal emulation program.
2. Load the connection settings of the setup menu and start the connection.
3. Press the R key in the terminal emulation program.
NOTE: As soon as the connection has been successfully established, the setup
menu (see figure on page 9) is displayed in the terminal emulation program.

Basic operation of the setup menu

How to operate the setup menu:
1. Use the
arrow keys
with  arrows .
2. Menu items whose settings are displayed in the right column can be changed by
pressing Space
Press to open a menu item that provides a sub dialogue.
Enter
3. If necessary, repeat steps 1 and 2 to change further settings.

Setup menu functions

Showing information about the firmware

The menu
Show Firmware Info
ware installed on the signal extender.
How to show information about the firmware in the terminal emulation
program:
1. Use the terminal emulation program to establish a connection.
2. Use the
arrow keys
3. Press to show information about the firmware in the terminal emulation
Enter
program.
4. Press to return to the main menu.
Q
10 · Audio-Transceiver-Fiber
to select the desired menu item. The active row is highlighted
(repeatedly).
shows you both the name and the version of the firm-
to select the row .
Show Firmware Info