Adjusting The Waiting Period Of The Screensaver - G&D VisionXS-IP-F-DP-UHR Installation Und Bedienung

Configuration
1. In the menu, click on
2. Click on the computer module (CPU) you want to configure and then click
on
Configuration
3. Click on the tab
4. Click on the tab
local workstation (on the
Click on the tab
remote workstation (on the
5. In the USB auto refresh
lowing options:
Only faulty devices
All devices
Off
6. Click on Save

Adjusting the waiting period of the screensaver

The screensaver turns off the display of the console after the user has been inactive
for a defined period of time.
NOTE:
This setting does not affect the screensaver settings of the computer con-
nected to the computer module.
How to adjust the waiting period of the screensaver:
1. Press Ctrl+Num
2. Select the row
3. Under
Screensaver (min)
screensaver.
Entering the value 0 disables the screensaver.
4. Press to save your settings.
F2
47 · G&D VisionXS-IP-F-DP-UHR
KVM extender
.
.
General
CPU if you want to change this setting of the
module).
CPU
CON if you want to change this setting of the
CON
field of the
 The status of the USB devices is monitored.
If communication to a USB device is interrupted, this
device is reinitialised (default setting).
 All USB devices are reinitialised regularly.
 The connected USB input devices do not need
to be reinitialised.
.
(default) to open the on-screen display.
and press
Console setup
enter a waiting period (1 to 999 minutes) for the
.
module).
Configuration section, select one of the fol-
.
Enter