Establishing The Power Supply; Installing The User Module - G&D DP1.2-VisionXG-Fiber Installation Und Bedienung

Installation

Establishing the power supply

Network B
USB 2.0 CPU Network A USB K/M
Main Power: Insert one of the supplied PowerCable-2 Standard IEC cables here.
Red. Power: Insert one of the supplied PowerCable-2 Standard IEC cables here. This es-
tablishes a second, redundant power supply for the user module.

Installing the user module

The remote console is connected to the
computer connected to the computer module can be operated over this console.
ADVICE: Connect the cables to the computer module preferably from left to right.
By doing so, you will avoid already connected cables blocking your view of the
interfaces.
Establishing a connection to up to two local networks
A
Transmission
NOTE: If desired, connect the network interface to up to two local networks. Now
you can not only access the
also send syslog messages to those networks.
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
11 · G&D DP1.2-VisionXG-Fiber
RS232
Line
PS/2 In Out USB CPU USB CPU
B
DP Out
Config Panel
Power
Red.
Main
PS/2 CPU PS/2 CPU
Ready Ident.
System Fail
DP1.2-VisionXG-Fiber-CON
Host
Link
USB 2.0 Devices
web application from those networks but
Main Power Red. Power
user module. The
Network B
Generic
Network A Keyb./Mouse PS/2