Temporarily Deactivating The Netfilter Rules - G&D DP1.2-VisionXG-Fiber Installation Und Bedienung

Using the Reset button

Temporarily deactivating the netfilter rules

In the default status of the KVM extender, all network computers have access to the
extender's IP address (open system access).
The web application enables you to create netfilter rules to control access to the
extender. As soon as a netfilter rule has been created, the open access to the system
is deactivated and all incoming data packets are compared to the netfilter rules.
If the currently adjusted netfilter rules prevent the access to the web application,
they can be can temporarily deactivated in order to be edited.
How to temporarily deactivate the netfilter rules:
1. Switch on the device if it has been switched off and wait until it is ready for oper-
ation.
2. Press and hold the Reset button on the front panel of the device for five seconds.
IMPORTANT:
Now, the open system access is activated.
3. Use the Config Panel
and, afterwards, save these rules.
IMPORTANT:
created within 15 minutes.
21 · G&D DP1.2-VisionXG-Fiber
web application to edit the netfilter rules stored in the device
The former settings are reactivated if no new netfilter rules are