Installation; Installing The Computer Module - G&D DP1.2-VisionXG-Fiber Installation Und Bedienung

Installation

Installing the computer module

The computer, whose signals are transmitted to the remote console, is connected to
the
DP1.2-VisionXG-Fiber-CPU
connected to the computer module.
Establishing a connection to up to two local networks
A
Transmission
NOTE:
If desired, connect the network interface to up to two local networks. Now
you can not only access the
also send syslog messages to those networks.
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse to the local console
Network B
Network A
USB 2.0 CPU USB K/M
NOTE: If you want to create a local console at the computer module, you can connect
either USB (interfaces USB K/M) or PS/2 (interfaces PS/2) mice and keyboards.
If necessary, use the adapter
board and a PS/2 mouse.
USB K/M: Connect the USB mouse and/or the USB keyboard of the local console.
PS/2: Connect the PS/2 keyboard of the local console.
ADVICE: Use the adapter
and a PS/2 mouse.
7 · G&D DP1.2-VisionXG-Fiber
computer module. A local console can optionally be
B
DP Out DP CPU
Config Panel
RS232
Line
In
PS/2 Out USB CPU
MD6M-2xMD6F
MD6M-2xMD6F
Host
Link
USB 2.0 CPU
web application from those networks but
Power
Red.
Main
PS/2 CPU Ready Ident.
System Fail
(A6400043) to connect a PS/2 key-
(A6400043) to connect a PS/2 keyboard
RS232
Network B
Network A
USB K/M PS/2
Main Power Red. Power