Possible Faults; Corrective Action - ATIKA MHB 80 Originalbetriebsanleitung

Before each fault elimination:
− Switch off device.
− Wait unitl the toeing tools come to a stop.
− Remove the spark plug connector.
− Wear gloves.
After each fault clearance, put into operation and recheck all security installations.
Fault code
Motor does not start
Engine starts and is
stalled immediately
Device works with
interruptions
Smoke
Machine does not work
with full performance
Toeing tools continue to
rotate at idling
Slipping of the toeing
tools
28
Possible cause
Incorrect starting sequence
Air filter contaminated.
Fuel filter fouled
No fuel supply
Fault in the fuel line
Cranking mechanism defective
Engine flooded.
Spark plug connector not placed on.
No ignition spark.
Engine defective.
Carburetor defective
Incorrect idle adjustment
Carburretor incorrectly adjusted
Spark plug fouled
Fuel line blocked
Water and dirt in the fuel tank
Carburretor incorrectly adjusted
Machine overloaded.
Air filter contaminated
Carburretor incorrectly adjusted
Silencer blocked
Clutch lever blocked
Incorrect clutch cable adjustment.
Too small clutch play

Possible faults

Corrective action

Observe the correct starting sequence
Clean/replace the air filter.
Clean or replace the fuel filter
Fill the fuel tank.
Check the fuel line for kinks or damages
Contact the customer service
Screw off, clean and dry the spark plug. Then pull
the cranking rope several times and reinstall the
spark plug
Place on the spark plug connector.
a) Clean or replace the spark plug.
b) Check the ignition cable.
c) Fault cannot be eliminated?
Contact the customer service
Contact the customer service
Contact the customer service
Contact the customer service
Contact the customer service
Clean or replace the spark plug Check the spark
plug connector.
Clean the fuel line/filter.
Drain the fuel tank and fill it with fresh fuel.
Contact the customer service
Too heavy soil, reduce the working depth.
Clean or replace the air filter
Contact the customer service
Clean the outlet of the silencer
Remove the blockage.
Adjust the clutch cable correctly.
Correct the clutch play.