Teaching In Without A Remote Transmitter; Teaching In/Deleting A Remote Transmitter; Operation; Programming - entrematic Magic 600-2 Bedienungsanleitung

• Press key C once briefly, teach-in procedure: The door
operator automatically stores "End position OPEN/CLOSE"
and the loads of the "Travel path OPEN/CLOSE". The door
operator lights flash in synchronism.
Teach-in is complete when the door is open and the door
operator lights are on.
Check load switch-off according to Chapter 9,Safety
inspection.

Teaching in without a remote transmitter

On the door operator:
• Press and hold pushbutton
open direction. Release pushbutton when the desired
opening position is reached. A correction can be made with
the pushbutton .
• Press the Menu pushbutton
automatically stores "End position OPEN/CLOSE" and the
loads of the "Travel path OPEN/CLOSE" . The door
operator lights flash in synchronism.
Teach-in is complete when the door is open and the door
operator lights are on.
Check load switch-off according to Chapter 9,Safety
inspection.
16 Teaching in/deleting a remote
transmitter
Programming the remote transmitter:
• During one of the 3 status messages A, B or C (seeChapter
10), press the pushbuttons
(approx. 1 s), F flashes in the display.
• Press the desired key on the remote transmitter, the radio
command is taught in. F appears in the display.
Note: F appears in the display during the transmission pulse.
Programming a new remote transmitter (TX) using an
existing one
Perform the following steps:
1 Go near door
2+3 programmed TX, within 3 seconds
4 new TX, within 10 seconds
5 wait 10 s
Deleting (all) remote transmitter(s):
During one of the 3 status messages A, B or C (see Chapter
10), press the pushbuttons
seconds, F flashes in the display. The status message
reappears after 3 seconds.
Magic 600-2
and the door moves in the
The door operator
and simultaneously
and simultaneously for >6

17 Operation

CAUTION: Mishandling the product can result in
injuries or material damage. Follow the basic safety
rules:
When opening or closing the door, do not block the interior or
exterior swivel ranges. Keep children away.
The door movements can be activated or stopped using the
remote transmitter provided or via switching elements such
as the wall keypad, which can be connected if desired.
Optional external features (such as the EMERGENCY
STOP) can also be connected to the door operator.
The operator must be connected to a door before
it is used. If it is not, incorrect load values will be
taught in to the electronic system. This can cause
malfunctions.

18 Programming

Switch on programming mode
During one of the 3 status messages A, B or C (seeChapter
10) press the Menu pusbutton
seconds. The display changes to the menu (D).
Select programming menu
Select the desired menu with the pushbuttons
2-character menu name flashes on and off. The following
appears for menu A0: A 0 A...
Show / change menu value
Displays: Press the Menu pushbutton
seconds, the menu value (E) is displayed.
Change: Change the value with the pushbuttons
Save: Press the Menu pushbutton
seconds, the programming menu (D) is displayed.
Exit programming mode
Press the Menu pushbutton
the display changes to the status message, changes are
saved.
If no key is pressed within 15 seconds during programming, it
automatically exits the programming mode.
A
IP2285 11/2017
for longer than 1.5
for less than 1.5
for longer than 1.5 seconds,
B C
D
D <1,5 Sek
>1,5 Sek
and . The
for less than 1.5
and .
E
E
15 / 206