Renkforce 751514 Bedienungsanleitung Seite 91

Installation
Proceed as follows to ensure correct installation:
A
Figure A-2
A) Remove the screw on the underside of the movement sensor housing.
B) Remove the screw which attaches the circuit board to the housing. Remove the circuit board.
C) Take the supplied mounting bracket for the movement sensor. Hold the mounting bracket on the in-
tended location and mark the position of the mounting holes. Drill the mounting holes and attach the
mounting bracket on the wall with suitable mounting materials.
Make sure that there are no electrical cables, water pipes etc. near the place you want to drill.
D) Figure "D" (see figure A-2 above) shows the pre-marked mounting location to which the mounting
bracket is attached to the housing.
E) Attach the mounting bracket as shown in figure "D" (see figure A-2 above).
F) Attach the circuit board again using the screw you removed previously.
G) Reconstruct the housing and refasten the screw on the underside of the housing.
C
B
LED
OFF ON
MODE
P
S
ALARM
N.O. N.C.
TAMPER
+ -
ALARM TAMPER
D
E
91