Renkforce 751514 Bedienungsanleitung Seite 118

Memory location for
telephone number
(press the displayed
digits on the control
panel)
60
61
62
63
Code = This is where you select whether a spoken message should be transmitted.
0 = Signal transmission activated
1 = Voice message is activated
In setting 0 the signal transmission is activated but you must set the number of signals before it
can function (Chapter 10.20). The factory setting is zero signals.
This means that the call will be made but no signal will be transmitted and the telephone dialler
switches off immediately.
If you have set the number of signals, no voice message can be played.
In setting one, ensure that the setting for signal transmission is switched off (Chapter 10.20). This
is the factory setting.
Telephone number =
It is not permitted to enter the telephone number of the police, fire brigade, emergency doctor
etc.
The call order is such that the first, then second, third and fourth numbers will be called.
After the telephone dialler has called the number, it immediately begins to play back the message or trans-
mit the sound signal.
118
Code
(enter the desired code on
the control panel)
0 or 1
0 or 1
0 or 1
0 or 1
The telephone number to be entered can be up to 32 digits long. Enter a telephone
number of an associate, friend or neighbour. You should inform them beforehand
about the voice message or signal tone to allow them to take the appropriate steps
in the case of an alarm.
Telephone Number
(enter the desired time in
seconds using the control
panel)
Maximum 32 digits
Maximum 32 digits
Maximum 32 digits
Maximum 32 digits
Confirmation
(press the displayed button
on the control panel)
#
#
#
#