Renkforce 751514 Bedienungsanleitung Seite 123

Example 3:
You have programmed 3 telephone numbers.
The call sequence is set to 2.
Message repetitions is set to 2
The call confirmation code is set to 1 (factory setting).
In an alarm situation the sequence with confirmation is as follows:
Telephone number
1st number
2nd number
If the code for call confirmation is set to 1 and the person called presses button 1 on his/her telephone
(which must be set to dual tone multifrequency) after the text message has been transmitted, then the
call recipient can listen to the room where the external microphone or the alarm control centre is located
for a predefined period of time After this period of time, the telephone dialler immediately ends the call
sequence and no more calls are made.
Memory location
73
Code = This is where you set the call confirmation.
0 = Signal transmission activated
1 = Voice message is activated
The factory setting for the code is 0.
Text message
1st repetition - signal tone
2nd repetition - signal tone
1st repetition - signal tone
2nd repetition - signal tone
Code
0 or 1
Telephone dialler hangs up.
Confirmation with button 1.
You can now listen to the room
for a predefined period of time
and then the telephone dialler
hangs up.
Confirmation
#
123