Programming; Start Programming Mode - Renkforce 751514 Bedienungsanleitung

10. Programming

You can carry out a large number of programming steps to suit the alarm control centre to your individual
needs. This includes setting the loops (delayed, direct or 24 hour loops) as well as programming the indivi-
dual outlets (setting the triggering time) and much more.
To do so you must enter the code for the programming mode, followed by the two digit code for the indivi-
dual programming steps.
Then enter the code for the change you wish to make and save with the # button. Two signal tone are
emitted as confirmation. If you hear 5 signal tones, the input has been declined. If you are unsure that the
entered code is correct, restart the programming from the beginning. To leave the programming mode
*
press the button twice.
If you do not make any input within 10 seconds (during programming) then you automatically
exit the input and return to the programming mode.
Ensure that the alarm control centre is fully connected and the lid is closed. The sabotage
contact of the alarm control centre must be closed.
Observe that the rechargeable battery is not connected yet, since the plant will report an error
otherwise and you can no longer programme the centre.

10.1 Start programming mode

You must enter the programming mode to carry out any changes to the alarm control centre.
This requires you to enter the master code followed by pressing the
The factory setting for the master code is 1234.
You should however definitely change this to your own personal master code. This means unau-
thorised individuals have no access to the programming mode.
Proceed as follows to enter the programming mode:
• Enter the four digit master code (factory setting for the master code = 1234).
• Confirm the input by pressing the "
• The control panel confirms the input with two signal tones.
• The LED "PROGRAM" lights up.
• You are now in programming mode.
*
" button twice.
*
button twice.
109