Programming Signal Sequence; Setting The Call Sequence; Setting Number Of Repetitions - Renkforce 751514 Bedienungsanleitung

10.13.3 Programming signal sequence

You can set the alarm control centre to emit a unique signal sound series after the call is made.
In this case it does not matter whether the signal transmission is activated or not. After the call
the entered series of sounds will be repeated once before the telephone dialler ends the call.
Example:
63 > 0 > 0987654321 > PAUSE > 5 > PAUSE > 1234 > #
Explanation:
63 Memory location for telephone number
Code selection for the series of digits
0
0987654321 Telephone number
End of the pause entry
PAUSE
5 Entered pause time (pause can vary from 1 to 99 seconds)
End of the pause entry
PAUSE
1234 Digit combination 1234 should be emitted (DTMF button tones)
Ende der Programmierung
#

10.14 Setting the call sequence

This chapter allows you to set the dialling sequence. You determine how often the telephone dialler dials
the individual telephone numbers.
Memory location
71
The factory setting for the sequence is 4.
If you have saved several telephone numbers, the telephone dialler pauses for approx. 5 seconds between
the numbers. If a new sequence begins (from the start) then the pause is 60 seconds.

10.15 Setting number of repetitions

This is where you set the number of times the voice message / signal sounds should be repeated.
Memory location
72
The factory setting for the repetitions is 4.
120
Code
1 to 8
Code
1 to 8
Confirmation
#
Confirmation
#