Optical - Renkforce 751514 Bedienungsanleitung

9.2 Optical

The remote control LEDs show the alarm control centre status.
LED lit ON:
ZONES
Loop is open (error).
(1 to 8) The loop must be
checked
EXIT/ARMED
The alarm system is
armed.
AC POWER Indicates that the
power supply is
correctly attached
and supplied.
BATTERY Error in battery
PROGRAM
The alarm control
centre is in pro-
gramming mode.
ARM The loop has an er-
PROHIBITED ror while the alarm
is armed.
DIALING Telephone in dual
tone multifrequency
(DTMF).
RECORDING Voice message is
being recorded
OFF:
Loop is closed and in
order
The alarm system is
disarmed.
Battery function correct Rechargeable battery is checked
Normal status
- Loop monitoring is
deactivated
- Loop function correct
No dialling telephone
line functioning cor-
rectly
No recording of voice
message
Flashes:
Flashing quickly:
Loop has been activated
Flashes quickly at intervals:
Loop has been activated and the alarm
control centre is currently disarmed.
Flashing slowly:
Loop has been deactivated
The alarm system is currently in the
exit delay period.
The power supply is not connected or
incorrectly connected, the alarm con-
trol centre is currently using battery
power.
The LED begins to flash approx. 20-30
seconds after the power is cut or beco-
mes incorrect.
Alternating flashing with "BATTERY"-
LED:
Rechargeable battery charging is acti-
vated and the battery is being charged.
Alternating flashing with "BATTERY"-
LED:
Rechargeable battery charging is acti-
vated and the battery is being charged.
The alarm control centre could not be
armed, as a loop has an error.
Telephone in pulse dialling mode (PD).
Flashing constantly: The telephone
line check was negative (check the
telephone line)
107