B) Programming The Special Functions - Reely Mustang Bedienungsanleitung

b) Programming the Special Functions

Attention!
Before you can operate the control unit and thus the vehicle itself, you must at least programme the
rechargeable battery type (NiMH or LiPo with 2 cells)!
The remaining settings do not need to be changed for the first drives. They are pre-programmed by the
manufacturer.
The speed controller unit offers many different programming options, e.g. adjustment of the braking strength, motor
brake function, low-voltage protection for LiPo rechargeable batteries and many others.
Proceed as follows:
• Switch on the transmitter. Leave the throttle lever in its neutral position.
• Switch on the speed controller.
The green LED is lit = reverse drive on
The yellow LED is lit = reverse drive off
Programming Rechargeable Battery Type
Attention!
The vehicle is only intended for 2-cell LiPo rechargeable batteries or 6-cell NiCd-/NiMH rechargeable
batteries. In this respect, see chapter 8. f).
Using battery packs with more cells will overload the drive (e.g. damage to the differential, etc.); loss of
warranty/guarantee!
The appropriate low voltage protection is activated during the initial programming of the battery type after the initial
commissioning of the speed controller. For NiCd/NiMH rechargeable batteries, the shutdown voltage is 4.5V, for LiPo
rechargeable batteries 6.0 V (2 cells).
• Press and hold the setup button until the red LED comes on. Only then release the setup button. The red LED
flashes; you are now in the setting mode for the rechargeable battery type.
• You can select the rechargeable battery type by briefly pressing the setup button. The flash rhythm of the red LED
changes.
Flash 1x
Battery type NiCd/NiMH
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
Switch off the speed controller and switch it back on again after a few seconds; then the speed controller is ready to
be used with the new settings.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
2x
LiPo rechargeable battery with 2 cells (7.4V)
49