Reely Mustang Bedienungsanleitung Seite 54

• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
Switch off the speed controller and switch it back on again after a few seconds; then the speed controller is ready to
be used with the new settings.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
Select Driver Profile
The speed controller has 5 pre-programmed driver profiles, which differ in their predefined settings. To select the
driver profiles, proceed as described below:
• Press and hold the setup button until all four LEDs come on. After they are lit, release the setup button. The four
LEDs flash (setting mode for driver profile).
• You can change the setting by briefly pressing the setup button. The flash rhythm of all four LEDs changes.
Flash
Driver profile
Reverse mode
Reverse mode proportion
Max. brake performance
Motor brake function
Dead Band
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
Switch off the speed controller and switch it back on again after a few seconds; then the speed controller is ready to
be used with the new settings.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
52
1x 2x
1 2
No Yes
0% 50%
30% 30%
15% 10%
3% 3%
3x 4x
3 4
Yes No
50% 0%
40% 40%
15% Off
4% 4%
5x
5
Yes
25%
30%
10%
3%