I) Attaching And Fastening The Car Body; J) Controlling The Vehicle - Reely Mustang Bedienungsanleitung

i) Attaching and Fastening the Vehicle Body
Push the aerial tube from the bottom of the body through the designated opening. Now put the car body on the holders
and fasten the vehicle lining with the safety clips removed at the beginning.
Your car is now ready for its first test run!

j) Controlling the Vehicle

Operate the throttle/braking lever for the drive function very cautiously and do not drive too fast at the
beginning until you get used to the reactions of the car.
Do not make any quick or jerky movements with the operating elements of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in the neutral position shortly
(neutral position = let go of lever, do not move it). If the throttle/brake lever is moved from forward to reverse directly,
the brake function of the drive is activated (vehicle will NOT reverse!).
The figures below only serve to illustrate the functions; they do not have to correspond to the design of the included
transmitter!
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move), lever is in neutral position
2. Drive forwards, slowly pull the throttle/brake lever towards the handle
3. Drive forwards and then brake (vehicle slows down; it does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping
4. Going forwards and then going in reverse (wait briefly between changes and leave the lever in its neutral position!)
42
Wait briefly