B) Programming The Special Functions - Reely Core XXL Bedienungsanleitung

b) Programming the Special Functions

The speed controller is already pre-programmed with the most sensible pre-settings ex works.
If you use a LiPo drive battery for operating the vehicle, you need to switch on the undervoltage protection
(recommended: 3.0 V/cell). With the undervoltage recognition deactivated, the LiPo drive battery will suffer
deep discharge and will be destroyed.
If a NiMH drive battery is used, switch off undervoltage recognition or set it to a lower value than for LiPo
drive batteries.
The programming can be performed very easily via the setup button.
Proceed as follows for programming:
• Switch on the transmitter.
• Switch off the speed controller ("OFF").
• Keep the setup button (B) pressed and turn the speed
controller on ("ON") via the on/off switch (A).
Continue to push and hold the setup button (B). Don't
release it.
• At the speed controller the red LED flashes and the mo-
tor emits beeps. Continue to push and hold the setup
button (B). Don't release it.
The beeps are generated by a short start-up of the brushless motor. These beeps may be very low, depend-
ing on the motor. In this case, observe the LED on the speed controller.
• After some time, the green LED flashes (keep the setup button (B) pushed, do not release it!) and the motor emits
beeps.
The number of green flashes of the LED (or the beeps of the motor) shows which setting function (1, 2, 3, 4 or 5) is
currently selected.
Note the table on the following page.
• When the desired setting function that you want to change is displayed (e.g. undervoltage protection, green LED
flashes 3x briefly + 3 short beeps), release the setup button (B) at once.
• Now the red LED flashes again and the motor emits beeps. The number of the flashes of the red LED and the beeps
show which set value is active (e.g. undervoltage protection 3.0 V/cell, LED flashes 4x briefly red and the motor
emits 4 brief beeps, followed by a break).
• Pushing the setup button (B) briefly changes the setting value. The number of red flashing signals of the LED and
motor beeps changes accordingly.
• To leave the setting mode and terminate programming, switch off the speed controller (move the slider (A) to the
"OFF" position). If you switch on the speed controller then, the speed controller is ready for operation with the set-
tings made above.
• If another setting is to be changed, proceed again as described above.
64
Æ
ON OFF