Reely Mustang Bedienungsanleitung Seite 52

Switching Reverse On/Off
• Press and hold the setup button until the blue LED comes on. Only then release the setup button. The blue LED
flashes (setting mode for reverse).
• You can switch the reverse mode on or off by briefly pressing the setup button. The flash rhythm of the blue LED
changes.
Flash 1x
Function Reverse mode is turned off.
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
Switch off the speed controller and switch it back on again after a few seconds; then the speed controller is ready to
be used with the new settings.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
Setting the Brake Performance
As with nearly all other speed controllers, the direct movement of the throttle lever on the transmitter from forwards to
reverse mode activates the brake. However this speed controller allows you to adjust the brake performance to your
requirements. Proceed as follows:
• Press and hold the setup button until the blue and green LEDs come on. After they are lit, release the setup button.
The blue and green LEDs flash (setting mode for brake performance).
• You can select the brake performance by briefly pressing the setup button. The flash rhythm of both LEDs changes.
Flash
Brake performance
• Hold down the setup button for at least 2 seconds; this saves the setting and the programming mode is exited.
Switch off the speed controller and switch it back on again after a few seconds; then the speed controller is ready to
be used with the new settings.
• If the setup button is not pressed for some 10 seconds, the programming mode is automatically exited without
saving the changes to the settings.
50
1x 2x 3x
10% 20% 30%
2x
Reverse mode turned on.
4x 5x 6x
40% 45% 50%
7x 8x 9x
55% 60% 65%
10x
70%