F) Switching On The Speed Controller; G) Attaching And Fastening The Car Body - Reely Alu Fighter Bedienungsanleitung

f) Switching on the Speed Controller

First switch on the transmitter, see chapter 8. d).
Place the vehicle on a suitable support as described in chapter 8. e) to ensure the wheels can turn freely.
Do not reach into the drive. Do not hold the wheels.
Put the trimming for steering and driving functions at the transmitter into its centre position.
Leave the throttle/brake lever at the transmitter in its neutral position and do not move it.
Then switch on the speed controller (switch position "ON").
The red LED at the speed controller should now flash 4 times, and the motor should
emit 4 beeps. The orange LED also lights up.
If the red LED does not flash after switching on and the motor does not emit any sound signals, while only
the orange LED is lit, the correct neutral position could not be recognised. In this case, set the trimming of
your transmitter correctly or programme the full throttle and neutral positions of the speed controller; see
chapter 10. a).
The sounds are generated by a short start-up of the brushless motor. Depending on the motor, this beep
may be very low or inaudible. In this case, observe the LED on the speed controller.
Then check the drive and steering functions of the vehicle; see chapter 8. h).
If the steering works opposed to the movement at the rotation knob at the transmitter (a turn to the left at
the transmitter makes the wheels go to the right), activate the steering reverse function.
The vehicle should drive forwards if you pull the throttle/brake lever at the transmitter towards the handle
If this is not the case, either reverse the motor's rotational direction (swap two of the three motor cables) or
activate the motor reverse function at the transmitter.

g) Attaching and Fastening the Car Body

Then put the car body on the holders of the chassis and fasten it with the car body clips removed at the start.
Your car is now ready for its first test run!
38
OFF ON