I) Attaching And Fastening The Car Body; J) Controlling The Vehicle - Reely Leopard Bedienungsanleitung

i) Attaching and Fastening the Vehicle Body
Push the aerial tube from the bottom of the body through the designated opening.
Now put the car body onto the holders and fasten it with the safety clips removed in the beginning; then proceed
accordingly with the rear spoiler.
Your car is now ready for its first test run!

j) Controlling the Vehicle

Operate the throttle/braking lever for the drive function very cautiously and do not drive too fast at the
beginning until you get used to the reactions of the car.
Do not make any quick or jerky movements with the operating elements of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter accordingly.
When switching between forward and reverse gears, the throttle/brake lever must be put in the neutral position (neu-
tral position = let go of lever, do not move it) briefly (approx. 2 seconds). If the throttle/brake lever is moved from
forward to reverse directly, the brake function of the drive is activated (vehicle will NOT reverse!).
Examples:
1. Release throttle/braking lever, vehicle rolls to a halt (or does not move), lever is in neutral position.
2. Drive forward, pull the throttle/brake lever towards the handle.
3. Drive forwards and then brake (vehicle slows down; does not roll to a halt slowly); push throttle/brake lever away
from the handle without stopping.
4. Drive forwards and then go into reverse (wait approx. 2 seconds between changes and leave the lever in its
neutral position!)
Wait approx. 2 seconds
39