F) Installation Of Receiver - Reely RHINO Bedienungsanleitung

Note!
When attaching the cable, please pay attention to also soldering on the free connections
of the suppression capacitor.

f) Installation of receiver

The receiver (1) is fastened with servo tape to the
vertical chassis plate (see also illustration 08, pos.
4).
Afterwards the antenna wire of the receiver is pushed
from the bottom through the wire holder (2).
Once the cruise control and the steering servo have
been connected to the receiver, you can fold the ca-
bles and secure them with a small cable fastener (3).
Now slide the antenna wire of the receiver through
the antenna tube (1) and insert it in the therefore
designated holder on the chassis link.
Afterwards fasten the coupling nut (2). Make sure
that the antenna wire does not drag on the cardan
shaft (3).
Illustration 9
Illustration 10
39