E) Ending Drive; F) Transport Of Vehicle - Reely RHINO Bedienungsanleitung

e) Stopping drive
To stop driving, you proceed as follows:
• Let the vehicle roll to a halt.
• Once the vehicle is stationary, take off the car body and put the on/off switch (if it exists) on the
vehicle in the "OFF" position.
Doing this, don't touch the wheels or the drive, under no circumstances move the operat-
ing lever for the drive function on the remote control!
• Separate the drive battery from the cruise control. Loosen the plug-in connection completely.
• Only now must the transmitter be turned off.
Warning!
Motor and drive battery can get very warm during operation and may possibly also get hot.
This is why you should not touch these parts straight after the drive.
Stop driving straight away when you notice unusual responses of the vehicle to the control
commands on the transmitter or when the vehicle no longer responds.
This behaviour could be caused by a weak vehicle battery, weak batteries/rechargeable
batteries in the remote control or by too high a distance between vehicle and remote con-
trol.
An antenna that was not pulled out all the way, disturbances on the radio channel used
(eg other models, radio transmissions through other devices) or adverse transmission/
reception conditions could also be a cause for unusual responses of the vehicle.

f) Transport of vehicle

For simple, secure and comfortable transport the
buggy is provided with a carrying strap (1) that is
mounted on the rear.
This makes it possible to carry the model without any
problems with only two fingers.
Illustration 14
43