Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; A) Removing The Vehicle Body; B) Installation Of Receiver Aerial Cable; C) Inserting Batteries/Rechargeable Batteries Into The Remote Control - Reely T-MAX Bedienungsanleitung

1:8 ep buggy 4wd rtr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen



8. Operation

a) Removing the vehicle body

The vehicle body is secured with holding clips which must be pulled out from the retaining pins. The vehicle body can
then be taken off.

b) Installation of receiver aerial cable

The receiver aerial cable is normally rolled up on delivery. Unroll the aerial cable completely and smoothen it carefully.
Run the aerial cable through the aerial tube and stick the aerial tube into the aerial mount on the vehicle.
A rubber cap might be enclosed for the aerial tube. Place it on the tip of the aerial tube to prevent the cable from
moving out of position.
Make sure the aerial cable does not get into the drive mechanism.
Never shorten the aerial cable, which would reduce the range. Do not coil up the cable if it does not fit
into the aerial tube! Just let it hang loose from the top of the aerial tube.

c) Inserting batteries/rechargeable batteries into the remote control

If you have not already done so, insert 8 batteries/rechargeable batteries into the remote control. Observe the correct
polarity (positive/+ and negative/-) as indicated in the battery compartment of the remote control. To open the battery
compartment, slide the lid forward and take it off.

d) Switching on the remote control

Always turn on the remote control (transmitter) before connecting the rechargeable battery packs to the speed controller.
There must be no other remote controls/models using the same frequency in the range of the remote
control, as they interfere with each other. As a result, the models no longer respond properly to the
remote commands. If other models are operated in your range, talk to the other operators to decide
what frequencies you use.
Check the Power LED (fig. 1, pos. 3) to make sure the batteries still provide enough power. If the red LED flashes due
to low battery power, stop operating the vehicle and switch it off. Then exchange the batteries or rechargeable batteries
with new ones.
30

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis