Reely RHINO Bedienungsanleitung Seite 36

Now fasten the servo with the help of 4 oval-head
screws (1) to the servo frame (2).
Doing this, make sure to screw in the right screws,
with their heads straight and that the servo cable
finds place in the therefore intended recess (3).
Afterwards hook the steering rods (1) into the servo
lever (2).
The further the rods are hooked away from the ro-
tating point, the bigger the turn achieved on the
wheels.
Now on the front left, place the servo frame into the
chassis, in accordance with the illustration.
The precise position is predefined by two chassis
mortisings that engage into the servo frame and
which are each located between the two drillings for
the holding screws.
Fastening the servo frame is carried out with the aid
of 4 counter-sunk screws (1), that are tightened from
the bottom through the chassis (2) into the frame.
This is where you should also make sure you are us-
ing the right screws. Afterwards the heads have to
be level with the chassis floor.
36
Illustration 3
Illustration 4
Illustration 5