Setting Options On Model Vehicle; A) Alignment; B) Inclination - Reely RHINO Bedienungsanleitung


10. Setting Options
 on the Model Vehicle
Once you have gotten familiar with the drive characteristics of the model, there is the option to optimize
the running characteristics of the model.
However, the explanations of the correlation between chassis set up settings and driving behaviour are
very complex and would go beyond the scope of these instructions. For this reason, we can only show
the setting options provided.
For further information we have to refer you to appropriate specialist magazines as well as comprehen-
sive reference books on this subject.

a) Alignment

Next to the already mentioned centrally adjustable
steering rods (1), the buggy is also provided with two
adjustable steering links (2) on the front axle. With
these links and rods the straight run as well as turn-
ing behaviour is adjusted.
With the help of a 5 mm flat spanner which is posi-
tioned on the centre piece (3) the steering rods can
easily be turned.
With the left/right thread the length of the complete
unit is changed and is therefore set to the desired
Illustration 15
value.

b) Inclination

In addition to the adjustable steering links the buggy
is equipped with adjustable transverse links (1) on
the front and rear axle, with the help of which you
can adjust the inclination of each wheel separately.
The setting is carried out through changing the
length when turning the right/left thread (2) with the
help of a 5 mm flat spanner.
Illustration 16
44