Putting The Furniture Door On Its Hinges And Adjusting It - Gaggenau RC 462 Montageanleitung

Mark this value X on the rear side of the furniture
D
door.
Determine the middle of the door and label it.
D
Loosen the two nuts and remove the adjusting rib.
D
Rest the adjusting rib on the furniture door and align
D
to the markings. Mark the drill holes.
Pre drill the holes.
D
Screw the adjusting rib tight.
D
Note:
- Attach the adjusting rib with at least 6 screws on the
furniture door. One screw should be screwed in
under the threaded rod in each case.
45,7 cm
61,0 cm
76,2 cm
* Wine storage cabinet
- The adjusting rib has a various holes for different
furniture door design variations. Always carry out
screwing jobs on the most stable part of the furniture
door.
21. Putting the furniture door on its
hinges and adjusting it
Note:
The height of the cabinet frontage is set using the
threaded rod.
Hang the furniture door on the threaded rod.
D
Adjust the furniture door using the threaded rod
D
(Torx screwdriver).
Transfer the middle drilled holes on the outside edge
D
of the appliance door to the furniture door.
Remove furniture door.
D
73