Preparing The Installation Niche - Gaggenau RC 462 Montageanleitung

Attach the hinge covers.
D
6.

Preparing the installation niche

Note:
For each appliance, two anti tilt ribs are needed.
In the case of a side by side combination, a total of two
anti tilt ribs are used.
Determine the fastening points of the anti tilt ribs.
D
Determine the actual dimensions according to the
section Installation Dimensions".
!
Caution!
Ensure that in the wall area there are no electrical wires or
pipes which could be damaged by pipes.
Risk of injury or damage!
62
If a installation niche is deeper than the appliance, lay
D
a strong wooden plank behind the anti tilt ribs and
screw tightly to the subsurface or the wall.
The length of the plank should correspond to the
width of the installation niche!
Important note:
As far as possible, always screw the wooden plank to the
rear wall of the niche.
In the case of some fitted shapes, it may be necessary to
screw in at an angle the wood screws used to fasten the
anti tilt ribs to the rear wall.
Important information for securing against tilting:
- The set supplied, contains fastening screws for
various subsurfaces. Select the fastening screws
corresponding to the local conditions.
- If it is not possible to securely fasten the anti tilt ribs
and consequently, not possible to securely fasten the
appliance using the fastening screws supplied, select
another suitable method for securely fastening the
anti tilt ribs.