Preparing The Furniture Doors - Gaggenau RC 462 Montageanleitung

18. Preparing the furniture doors

Important note:
When working on the furniture doors, care should be
taken to the following:
- Always carry out screwing jobs on the most stable
part of the furniture door. Never screw into fillings or
similar areas.
- Always selects screws with a length smaller than the
thickness of the cabinet front.
- Protect the surfaces of the furniture doors during
installation against damage.
The overall weight of the furniture door including the
handle should not exceed the following values:
Appliance width Overall width of the furniture door
45.7 cm / 18"
61.0 cm / 24"
76.2 cm / 30"
The furniture doors are attached to the appliance with the
fastening elements located on the appliance. Using these
fastening elements, this allows the furniture door to be
adjusted accurately and securely attached to the
appliance.
Function of the various parts:
1. Threaded rod on the adjusting rib:
for adjusting the furniture door vertically.
2. Fixing angle:
for adjusting the cabinet frontage in terms of depth.
3. Nuts on the threaded rod:
for securing the cabinet front in order to prevent
lateral sliding.
4. Lower fixing angle:
for securing the cabinet front in order to prevent
lateral sliding.
17 kg
23 kg
30 kg
Connecting element for furniture doors
Instead of one large door, two furniture doors can be
mounted next to each other in the case of appliances
with a width of 76 and 91 cm (30" and 36").
These furniture doors are then connected using
a metal strip on the rear.4.
This metal strip is available from your Gaggenau dealer as
an installation accessory (Connection element for
furniture doors). For further details see section Tools
and Accessories which are needed".
71