Attaching An Additional Anti Tilt Mechanism - Gaggenau RC 462 Montageanleitung

7. Attaching an additional anti tilt
mechanism
Important note:
As far as possible, always screw the wooden plank to the
rear wall of the niche.
If the anti tilt ribs cannot be fastened securely, a wooden
beam can be used above the appliance as an alternative
anti tilt mechanism. Care should be taken that there is
not a gap between the appliance and the wooden beam.
Cut the wooden plank to the required length (cross
D
section min. 8 x 10 cm).
The length should correspond to the width of the
installation niche!
Note:
- If the installation niche is deeper than the appliance,
select a stronger beam or use two, one behind the
other.
- The plank must overlap the appliance by at least
50 mm.
Mark the installation height (underside edge of the
D
plank) on the rear wall of the niche.
64
Select the screws according to the thickness of the
D
wooden plank: Length min. 2.5 x wood thickness,
diameter 12 or 14 mm.
Note:
Select the number of screws corresponding to the niche
width so that you ensure that the plank can be securely
mounted.
According to the subsurface:
Look for the supports on the rear wall of the niche
D
and mark the drill holes on the plank corresponding
to the position of the support.
or
Fasten suitable dowel into the rear wall.
D
Pre drill.
D
Screw the plank onto the rear wall of the niche.
D