Setting Up Side By Side - Gaggenau RC 462 Montageanleitung

Setting up side by side

The dimensions stated for the respective appliance also
apply for the installation of two appliances next to each
other.
The overall width of the niche is made up by adding the
niche widths necessary for the individual appliances.
Key:
A Area for installation of the water connection
The shut off valve for the appliance's water connection is to
be located in the immediate vicinity of the installation niche
such that it is accessible without disassembling the
appliance.
If this is absolutely unavoidable, the shut off valve should be
only be installed in the area of the installation areas labelled
with A and B behind the appliance.
B Area for installation of the electric current
50
Example:
Freezer 45.7cm wide / Refrigerator 76.2 cm wide
Important!
The upper niche wall must consist of a rigid, load bearing
material (minimum thickness 16 mm). The upper niche wall
must be completely even up to a depth of at least 100 mm
and free from bumps.
Important!
The lateral niche walls must be completely even and free
from bumps. If the niche is formed as a separate part, the
side walls must be completely even up to a depth of at least
100 mm and free from bumps.
D Depth of the installation niche, depending on the
kitchen design (see DESIGN GUIDE)
D = 610 mm minimum!
Note:
The installation niche must have right angles. The side
walls should not exhibit areas that stick out, projections
or unevenness.