Slowly close the door. Re examine to see if the air
D
filter hits any parts of the ventilation grille.
If necessary, shorten the longitudinal side of the air
filter by a maximum of 6 mm.
Only in the case of freezers with ice and water
dispenser:
Air filter must be trimmed in the area of the hose
D
(see point 2 in the illustration).
29. Setting the door opening angle
According to the set up conditions, it may be necessary
to limit the door opening angle. A door opening angle of
115° is set at the factory.
To set the door opening angle to 90°:
Open the door to 90°.
D
Insert stopper rod in the drill holes which are now
D
vertically on top of each other and drive home with
a hammer.
30. Tightening the hinges
To activate the hinges:
Turn the setting screw with a cross head screwdriver.
D
I = screw tension activated
0 = screw tension not activated
81