Shortening The Finger Protection; Fitting The Finger Protection - Gaggenau RC 462 Montageanleitung

The number of the lower fastening angles depends
on the width and the design of the furniture door.

23. Shortening the finger protection

Important note:
The finger protection must cover the door gap over the
full length. If the height of the door exceeds the standard
height, the extra long finger protection (see Additional
accessories") has to be used.
Pull the finger protection up to the hinge side of the
D
door. The sections on the finger protection have to be
exactly aligned to the height of the fastening clips.
Transfer the door dimensions (upper/below) to the
D
finger protection.
Shorten the finger protection using a steel rule and
D
a knife to the required length.
76

24. Fitting the finger protection

Push the finger protection into the gap between the
D
appliance and the niche wall (1.).
Clamp the finger protection to the fastening clips (2.).
D
Clamp the holding clips under the screws.
D
Screw tightly.