Fastening The Furniture Door - Gaggenau RC 462 Montageanleitung

On both lengths of the furniture door, draw a parallel
D
with the help of the positioning aid.
Lengthen the drill hole markings to the parallels using
D
an angle of contact.
Apply the fixing plates and mark out the holes.
D
Pre drill the holes.
D
Screw on the fixing plates (10x).
D
74

22. Fastening the furniture door

Important note:
Now attach the door handles which should have
been screwed from behind!
Hang the furniture door on the threaded rod.
D
Screw the nuts on the threaded rod. Do not screw
D
tightly!
Adjust the furniture door as accurately as possible.
D
Note:
When adjusting, the door must be opened and closed
often owing to circumstances. To make this procedure
easier, proceed as follows:
Insert the fixing angle directly behind the door handle into
the corresponding fixing plate. Slide the fixing angle on
the screw on the appliance door and screw tightly. After
adjusting, loosen the fixing angle again.
Adjust the furniture door with the threaded rod
D
(Torx screwdriver). Re examine the dimensions
of the crack continuously.