Gaggenau RC 462 Montageanleitung Seite 75

Attaching the fixing angles:
D
Lift the furniture door somewhat from the appliance
door.
Press the upper fixing angles (without the flap (1.))
right and left over the screws.
Insert the fixing angles (with the flap (2.)) right and left
into the fixing plates and slide over the screws on the
appliance door. Slowly lower the door in order to
repeat the procedure in (2).
Continue until the last fixing angles (6.) are inserted
into the fixing plate and fastened to the screws.
Close the door and re examine to make sure that the
D
depth of the cabinet frontage corresponds with the
adjacent lying fronts. Correct if necessary.
Tighten the fixing angle screws in order to fix the
D
depth adjustment.
Close the door and check the lateral adjustment.
D
Correct the adjustment by lightly banging on the
edge of the open door by hand.
Screw the nuts on the adjusting rib tightly. This way,
D
the lateral adjustment of the door is fixed.
Screw on the lower fastening angles from the
D
auxiliary set. Pre drill holes into the furniture door!
The lateral adjustment of the door is fixed through
the lower fastening angles.
1. Loosen screw.
2. Check the lateral position of the door.
3. Screw in the wood screws.
4. Tighten the screws.
5. Place coverings over the fastening angles.
75