Removing The Packaging; Preparing The Appliance - Gaggenau RC 462 Montageanleitung

3.

Removing the packaging

!
Warning!
- The appliance could tip over when unpacking.
- The appliance is very heavy.
- The appliance could tip over when the appliance
door is opened.
Handle it carefully, as otherwise people helping to lift it
could be hurt or the appliance could be damaged.
To protect the subsurface from damage whilst installing:
Put a carpet or spare piece of linoleum (or other such
D
item) down and attach it to the floor using adhesive
tape in front of the planned fitting site.
!
Warning!
Always place the means of transport centrally on the rear
side of the appliance. Never push it in from the front or
from the side under the appliance.
Risk of damage to the appliance!
Move the appliance using a trolley, sack barrow or
D
wheelbarrow.
Removing the transportation packaging:
D
Remove the cardboard. Be careful when using the
knife so as not to damage the surface of the
appliance.
Take the supplied accessories from the protective
parts of the packaging.
!
Warning!
Only remove the transporting securing units with which
the slide in bases and the storage compartments in the
appliance are protected after completing the installation
as otherwise, parts could be damaged.
Check the appliance for damage.
D
Do not install the appliance if there is visible damage.
If there are queries, please contact the dealer.
4.

Preparing the appliance

Remove the lateral fastenings and fastening sheets
D
with which the cabinet fronts are attached. To do
this, loosen the fastening screws and remove the
stops.
Note:
Keep the stops safe as otherwise they may become lost.
59