Switching The Appliance On For The First Time - Gaggenau RC 462 Montageanleitung

Measure the difference in depth Y between the base
D
panelling and the base strip of the adjacent lower
cabinets.
Remove the base panelling again.
D
Loosen the fastening joint of the base panelling.
D
Take out/slide in the joint around the measured
D
depth Y.
Screw the joint again tightly.
D
70
Fasten the base panelling.
D
Note:
If necessary, the base strip can also be screwed to the
base panelling. Pre drilled screw holes are located in the
base panelling in the area of the Velcro strip.
17. Switching the appliance on for the
first time
The appliance should now be switched on for the first
time in order to ensure the accuracy of the following
mounting steps and with it, the appearance of the entire
kitchen frontage.
Open the appliance door.
D
Actuate the appliance's on/off button.
D
Only for appliances with a water connection:
In the case of possible damage of the water mains, keep
the shut off tap closed in order to avoid the risk of
damage from water coming out.