Listing (Analyzing); Trend Output (Analyzing); Output .Txt File (Analyzing) - LumaSense Technologies mpac IN 140/5-L Betriebsanleitung

IMPAC pyrometers IN 140/5 · IN 140/5-H · IN 140/5-L
• With "Mark zone" a temperature range can color marked for easier recognition.
• Setting a temperature under "Threshold" prevents the recording of values above or below this tempera-
ture to keep the file size small.
• With "Scaling trend" the view of the temperature range can be limited.
The measuring values of "measurement color bar" or "measurement online trend" are
Note:
automatically saved as "standard.i12". Should you need to edit the data later, you
need to save the file as another .i12-file because old values are over-written when a
new measurement is taken.
Files from older program versions (.i10-files) can be opened and saved as .i12.
10.9

Listing (analyzing)

For analyzing the measured values
in this field all measured data ap-
pears in a numeric list.
The date beside the time gives more ex-
actly values to see what happened on time
units smaller 1 s. The value specifies the
time in seconds after midnight (0:00 h). The
amount of data depends on the frequency
that readings were taken (settings at 0
Time interval between two measure-
ments). As the amount of data increases,
so does the amount of storage space re-
quired to save it. In order to save room, all
.i12 data files are stored by a binary code.
10.10

Trend output (analyzing)

The graph's curve depicts the
temperature change over time
within the specified temperature
range.
Additionally, other information appears in
this window; such as recorded time (x-axis)
and temperature in degrees (y-axis) as well
as the time and temperature at the vertical
cursor line which can be dragged with the
mouse.
Selecting the Trend output initially causes
all the saved data to be displayed.
If the data exceeds an amount that can be
represented reasonably, you may "Zoom" in
on a partial segment using the mouse (such
as the segment represented in the example).
Under "Total" you can return to the represen-
tation of the entire curve.
The last reading is saved in the standard.i12 file and automatically appears in this
Note:
form upon opening Listing or Trend output.
If file open was loaded using another file, the previous file will be overwritten and
replaced by the standard.i12 file.
10.11

Output .TXT file (analyzing)

The same file as under „Output listing" may be converted into a text file and can be easily opened,
for example with EXCEL. With the standard import settings EXCEL automatically formats the col-
umns accordingly (tabulator as separators).
20