Disconnecting And Securing The Lathe; Using Lifting Equipment; Mechanical Maintenance Work - Optimum OPTIturn TU 2506 Betriebsanleitung


Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other competent supervisory authority, responsible for your company.

Stay at the lathe until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.
We specially point out the specific dangers when working with and on the machine.
1.13

Disconnecting and securing the lathe


Pull the mains plug before beginning any maintenance or repair work or or switch off the
supply voltage to the lathe. All machine components and hazardous voltages and move-
ments are disconnected.

Secure the machine using a padlock on the lockable main switch (only TU2506 / TU2807
Vario).

Attach a warning sign on the machine.
1.14

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension gear that might break under load can
cause severe injuries or even death.
Check that the lifting equipment and load-suspension gears are of sufficient load
capacity and are in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other competent supervisory authority, responsible for your
company.
Fasten the loads properly.
Never walk under suspended loads!
1.15

Mechanical maintenance work

Remove or install protection safety devices before starting any maintenance work and re-install
them once the work has been completed.This includes:

Covers,

Safety indications and warning signs,

earth (ground) connections.
If you remove protection or safety devices, refit them immediately after completing the work.
Check if they are working properly!
Safety
Version 1.0.1 2014-05-16
TU2506 | TU2506V | TU2807 | TU2807V
Original operating instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
GB
Page 93