Changing The Change Gears - Optimum OPTIturn TU 2506 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y

3.14.2 Changing the change gears

The change gears for the feed
are mounted on a quadrant.

Disconnect the machine
from the electrical supply.

Loosen the locking screw on
the quadrant.

Swing the quadrant to the
right.

Remove the lock washers of
the clamping screws at the
quadrant.

Remove the screw from the
shaft of the feed gear.

Loosen the clamping screws
on the quadrant.

Install the gear couples using the feed or change gear table and screw the gearwheels onto
the quadrant again.
GB TU2506 | TU2506V | TU2807 | TU2807V
Page 118
Change gear quad-
rant
Clamping screw
Hexagon key
Lock washer
Screw
Clamping screws
Original operating instructions
Img.3-15: Locking screw quadrant
Img.3-16: Tilted quadrant
Img.3-17: Attachment of change gears
Img.3-18: Attachment of change gears
Version 1.0.1 2014-05-16